The new servo hydraulic press is an environment-friendly, energy-saving and high-efficiency hydraulic press that uses an AC servo motor to drive the gasoline pump of the main transmission system, reduce the control circuit of the pressure regulating valve and adjust the rollers of the hydraulic press. Suitable for stamping die, free forging, riveting, straightening and other processing processes.

1、 The operator shall master the basic principle of the hydraulic press system, the actual effect of the main hydraulic system of the machine and equipment, and the operation sequence of the management system. Before starting the machinery and equipment, check whether all fitness mechanisms and relays are in the starting state, and query the oil volume of the automobile fuel tank. If there is abnormality or the remaining oil is insufficient, it is strictly prohibited to start the hydraulic oil pump motor, and find the maintenance staff to repair it. The operator shall often inquire about the working condition of the hydraulic press management system, observe the working pressure and speed, and inquire about the product workpiece limit and the damage of game props, so as to ensure the stability and firmness of the hydraulic press management system.

2、 In winter, when the temperature of the automobile oil tank does not reach 25 ℃, the implementing mechanisms can not start working in sequence, but only start the hydraulic oil pump motor to make the hydraulic oil pump work empty. During the summer work process, when the temperature in the automobile oil tank is higher than 60 ℃, pay attention to investigate the working condition of the hydraulic press management system, and inform the maintenance staff to solve it. The operator shall not destroy the self-locking and interlocking machinery and equipment of the electrical equipment management system, push the motor control valve, or destroy or arbitrarily move the direction of each actual operation gear.

3、 Shut down the hydraulic press for about 4 hours. Before starting work, start the hydraulic oil pump motor for 5-10min, and then it can work with working pressure. When there is a problem with the hydraulic press management system, the operator cannot move around automatically without authorization, and should report to the maintenance department immediately. The hydraulic machinery shall be cleaned constantly to prevent floating dust, cutting oil for drilling, drilling, pure cotton yarn and other impurities from entering the automobile fuel tank.